X-Rock Black 24×24 2CM Porcelain Paver – Natural
Elevate outdoor living with the X-Rock Black 24×24 2CM Porcelain Paver. Its deep black tone and natural finish establish a sleek, contemporary backdrop for patios, walkways, and open‑air rooms, pairing seamlessly with modern landscape materials.
Built for exterior performance, this 20 mm (2CM / 3/4 in.) porcelain paver offers frost resistance for year‑round climates and rectified edges for crisp, consistent joint lines. Low‑maintenance care simplifies life outdoors, while a PEI 4 wear rating supports durable surface performance when installed to standards.
Features
- 24×24 large-format 20 mm (2CM) porcelain paver
- Color: Black with a Natural finish
- Rectified edges for precise, consistent joints
- 3/4 in. (2CM) thickness for robust outdoor builds
- PEI 4 wear rating for durable performance
- Frost resistant for year‑round outdoor use
- Low maintenance and easy to clean
- Approx. 7.75 sq ft per box coverage
Recommended Applications
- Patios
- Pool Decks
- Walkways
- Garden Paths
- Outdoor Kitchens
- Outdoor Living Areas
- Rooftop Terraces
- Courtyards
Installation Guide – X-Rock Black 24×24 2CM Porcelain Paver – Natural
Important Advisory
This guidance applies to the installation of X-Rock Black 24×24 2CM Porcelain Pavers. Always follow manufacturer instructions, local building codes, substrate and drainage requirements, and current industry standards (e.g., TCNA/ANSI) before starting any project.
Step 1: Layout & Planning
- Dry‑lay multiple pavers to review shade, size calibration, and layout before installation.
- Plan patterns and cuts to achieve balanced joints and avoid narrow slivers at perimeters.
- Establish control lines with chalk or a laser and verify slope for proper drainage away from structures.
Step 2: Paver Installation
- Install 24×24 porcelain pavers over a properly prepared and compacted sand setting bed, a bonded mortar bed, or an adjustable pedestal system approved for 2CM porcelain.
- Confirm adequate slope and drainage per local codes and site conditions.
- Maintain consistent joint spacing (typically about 1/8"–3/16") using appropriate spacers.
- Seat each paver with a rubber mallet to ensure full support without damaging the rectified edges or surface.
- Check alignment, flatness, and joint consistency frequently; incorporate movement joints per standards and project conditions.
Step 3: Cutting
- Use a wet saw with a premium diamond blade rated for porcelain.
- Fully support the paver during cutting to minimize edge chipping and improve accuracy.
- Measure carefully, mark clearly, and wear appropriate PPE.
- Avoid dry cutting where possible and control dust per safety regulations.
Step 4: Joint Filling
- For sand‑set installations, fill joints with polymeric sand or another jointing material approved for porcelain pavers and outdoor use.
- For mortar‑set installations, use an exterior‑grade grout per manufacturer guidance; clean as you go to prevent haze.
- On pedestal systems, follow pedestal and spacer manufacturer recommendations for joint treatment and perimeter restraint.
- Remove all excess jointing material from the surface before curing and final cleaning.
Step 5: Cleaning & Maintenance
- Routinely clean with water and a pH‑neutral cleaner using non‑abrasive tools.
- Avoid acidic, bleach‑based, or abrasive products that may harm surrounding materials or finishes.
- Promptly remove construction residues and grout haze per manufacturer recommendations.
- Porcelain pavers generally do not require sealing; inspect joints and borders periodically and maintain as needed.
Disclaimer
Shade and size variation can occur between production runs; verify caliber and dye lot before installation. Inspect all materials prior to install—installed materials are considered accepted. Professional installation is recommended to ensure code compliance, structural integrity, and long‑term performance.
