Statik Electrik 12×24 Porcelain Tile Natural Rectified
Refined and contemporary, the Statik Electrik 12×24 porcelain tile offers a versatile natural (matte) surface with precise rectified edges for clean, consistent joints. The 12×24 format creates smooth, modern expanses across walls and feature areas while supporting thoughtful, minimal grout lines.
Built in durable porcelain and frost resistant, Statik Electrik broadens design possibilities to exterior facades in freeze–thaw climates. Pair it with a range of finishes and fixtures to achieve cohesive residential or commercial wall installations with low-maintenance performance.
Note: With a reported DCOF <0.42, evaluate slip-resistance requirements before considering any floor use and follow applicable standards.
Features
- Material: Porcelain
- Collection: Statik
- Color: Electrik
- Finish: Natural (matte)
- Edge: Rectified
- Size: 12×24 rectangle
- PEI rating: 3
- DCOF: <0.42
- Frost resistant for freeze–thaw exterior wall applications
- Coverage: 11.63 sq. ft. per box | 6 pieces per box | 1.938 sq. ft. per piece
Recommended Applications
- Residential interior walls
- Commercial interior walls
- Backsplashes
- Shower walls
- Fireplace surrounds
- Exterior walls/facades (freeze–thaw)
Installation Guide – Statik Electrik 12×24 Porcelain Tile Natural Rectified
Important Advisory
Always follow the tile manufacturer’s instructions, local building codes, and recognized industry standards (ANSI A108/A118 and TCNA guidelines). Confirm substrate suitability, movement accommodation, and required waterproofing/drainage for wet or exterior locations.
Step 1: Layout & Planning
- Verify the substrate is clean, dry, sound, and flat within industry tolerances for the chosen tile size.
- Plan the layout by dry-laying tiles, centering the pattern, and avoiding sliver cuts at perimeters.
- Blend tiles from multiple boxes to distribute any shade variation evenly.
- Select spacers appropriate for rectified tile and include movement joints per TCNA EJ171 and project conditions.
Step 2: Tile Installation
- Use a polymer-modified thin-set mortar approved for porcelain tile and the site conditions (interior/exterior, wall).
- Key mortar into the substrate, then comb in one direction with a notched trowel; back-butter tiles as needed to improve coverage.
- Set tiles with a slight sliding motion to collapse ridges and achieve proper bond; verify coverage per standards and application.
- Use a leveling system if needed to help control lippage on larger-format layouts.
- Allow mortar to cure per manufacturer instructions before grouting or applying load.
Step 3: Cutting
- Cut using a wet saw with a premium diamond blade designed for porcelain.
- Measure and mark carefully; support the tile fully during cuts to minimize chipping.
- Ease sharp cut edges as needed at exposed transitions.
Step 4: Joint Filling
- Select a grout suitable for porcelain and the intended joint width; follow manufacturer directions for mixing and cure.
- Pack joints fully with a rubber float, clean diagonally, and remove haze promptly with clean water.
- Use appropriate sealant at movement joints and all changes of plane; do not grout these areas.
- Protect the installation from traffic and moisture until grout has cured.
Step 5: Cleaning & Maintenance
- Clean routinely with a pH-neutral cleaner suitable for porcelain; avoid harsh acids or abrasive tools.
- Use entry mats and protective pads to reduce tracked-in grit and potential scratching on adjacent finishes.
- Follow grout and mortar manufacturers’ maintenance recommendations; seal cementitious grout if specified.
Disclaimer
Installation should be performed by qualified professionals. Confirm actual materials, lot-to-lot variations, and suitability for specific applications before installation. Stone Market USA is not responsible for issues from improper installation, handling, or site conditions.
