Nextone Taupe 12×24 Porcelain Tile Natural Rectified
Understated and modern, Nextone Taupe brings a warm neutral tone in a natural (matte) finish that complements a wide range of interiors. The 12×24 format reduces grout lines for a cleaner look, while precise rectified edges help achieve tight, consistent joints on floors and walls.
Crafted in durable porcelain with a 10mm (3/8) thickness, this tile carries a robust PEI 5 wear rating for high-traffic spaces. Frost resistance broadens design options to exterior facades in freeze–thaw climates. Box coverage is 15.5 sq ft (8 pieces), simplifying estimates and planning.
Use Nextone Taupe alone for a calm, continuous surface or mix it with contrasting materials for layered detail across kitchens, baths, living areas, and commercial wall designs.
Features
- Porcelain body for durability and easy maintenance
- Color: Taupe
- Finish: Natural (matte)
- Edge: Rectified for clean, uniform joints
- Size: 12×24 format; Thickness: 10mm (3/8)
- PEI 5 wear rating for demanding residential and commercial floors
- Frost resistant for freeze–thaw exterior wall applications
- Coverage: approx. 1.94 sq ft per piece | 15.5 sq ft per box | 8 pieces per box
Recommended Applications
- Residential interior floors
- Residential interior walls
- Commercial interior floors
- Commercial interior walls
- Backsplashes
- Shower walls
- Fireplace surrounds
- Exterior walls/facades (freeze–thaw)
Installation Guide – Nextone Taupe 12×24 Porcelain Tile Natural Rectified
Important Advisory
Follow the tile manufacturer’s instructions, local building codes, and industry standards (ANSI A108/A118 and TCNA guidelines). Verify substrate suitability, flatness, movement accommodation, and waterproofing/drainage where required.
Step 1: Layout & Planning
- Confirm the substrate is clean, dry, structurally sound, and flat within tolerances appropriate for 12×24 tile.
- Dry-lay to balance cuts and align grout joints; center the layout to avoid narrow slivers at perimeters.
- Blend tiles from multiple boxes to distribute shade/pattern variation.
- Plan joint width appropriate for rectified tile and include movement joints per TCNA EJ171.
Step 2: Tile Installation
- Use a polymer-modified thin-set mortar approved for porcelain and the project conditions (interior/exterior, wall/floor).
- Key mortar into the substrate, comb with an appropriate notched trowel, and back-butter tiles as needed to improve contact.
- Set tiles with a slight slide to collapse ridges; achieve the coverage required by application and location (typically 80–95%).
- Use a leveling system when helpful to reduce lippage on larger-format installations.
- Allow mortar to cure per manufacturer guidance before grouting or opening to light traffic.
Step 3: Cutting
- Cut with a wet saw and a quality diamond blade suited for porcelain.
- Support the tile fully and mark cuts accurately to minimize chipping.
- Ease cut edges where they will be exposed.
Step 4: Joint Filling
- Select grout suitable for porcelain and the planned joint width; mix and apply per manufacturer directions.
- Fully pack joints with a rubber float; clean diagonally and remove haze promptly with clean water.
- Use flexible sealants at movement joints and changes of plane; do not grout these areas.
- Protect the installation from traffic until grout has cured.
Step 5: Cleaning & Maintenance
- Clean routinely with a pH‑neutral cleaner approved for porcelain tile; avoid acids and harsh abrasives.
- Use entry mats and felt pads to limit tracked grit and scratching.
- Follow grout manufacturer maintenance guidance; seal cementitious grout if recommended.
Disclaimer
Installation should be performed by qualified professionals. Confirm actual materials, lot variations, and application suitability before installation. Stone Market USA is not responsible for issues arising from improper installation, handling, or site conditions.
