Carrara White OG-1 Chair Rail Trim 2″x12″ – Classic Elegance in Polished Marble
Bring timeless charm to your walls with the Carrara White OG-1 Chair Rail Trim 2″x12″. Made from genuine Carrara marble, this trim showcases a polished finish that reflects light beautifully. Its soft white base and gentle gray veining provide a luxurious yet subtle accent to any design scheme.
Thanks to its OG-1 profile, this molding adds depth and architectural interest to your tile installations. Whether you’re defining wainscoting, finishing a backsplash, or framing a feature wall, this trim creates smooth and elegant transitions. It works well in both traditional and modern interiors, adding a refined touch without overwhelming the space.
Product Features
- Material: Premium Carrara White Marble
- Finish: Polished – bright and reflective surface
- Size: 2″ x 12″ (5.1 x 30.5 cm)
- Profile: OG-1 curved decorative profile
- Color: White with soft grey veining
- Edge: Finished edges for clean transitions
- Recommended Use: Wainscot borders, backsplash caps, shower walls, accent lines
Why Choose This Chair Rail Trim?
Incorporating this polished chair rail trim adds elegance and structure to any interior. Moreover, its durable stone composition makes it a lasting choice. With its classic detailing and high-end material, it elevates even the simplest tile layout.
Installation Guide – Carrara White Polished Marble Chair Rail Trim (2″x12″)
Step 1: Surface Preparation – Prepare the Wall for Installation
- Ensure the wall surface is flat, clean, and dry.
- Complete any adjacent tile installation first—chair rail is typically installed last as a finishing edge.
- Use a level to mark a horizontal guide line where the chair rail will be placed—typically 32–36 inches above the floor or at the top of the tile field.
Step 2: Dry Layout – Align and Preview
- Dry-lay all trim pieces along the intended area to confirm fit and alignment.
- Match veining direction and polish tone for a continuous visual flow.
- Cut pieces to size using a wet saw with a fine diamond blade. Use care to preserve the polished finish.
Step 3: Adhesive Application – Wall-Mount Installation
Recommended Adhesives:
- Laticrete 254 Platinum White
- Mapei Ultralite Mortar (non-sag, white)
Instructions:
- Apply white thin-set mortar to the back of each piece using a margin or V-notch trowel.
- Back-butter the trim for optimal adhesion.
- Firmly press the chair rail onto the wall along the guide line. Hold in place for a few seconds to ensure grip.
- If needed, use painter’s tape to support heavier pieces until the adhesive sets.
Step 4: Grouting – Clean Transitions
- Allow 24 hours for adhesive curing before grouting.
- Use non-sanded grout to avoid scratching the polished marble surface.
- Apply grout with a rubber float or grout bag, clean excess grout immediately with a damp sponge.
- Buff the surface with a microfiber cloth after 30–45 minutes to remove haze.
Step 5: Sealing – Long-Term Protection
- Apply a penetrating marble-safe sealer after grout has fully cured (typically 72 hours).
- Re-seal periodically, especially in wet or high-traffic areas.
Maintenance Tips
- Use only pH-neutral stone-safe cleaners—avoid acidic or abrasive products.
- Dust and wipe with a soft cloth to maintain the polished sheen.
- Protect edges during adjacent cleaning or construction work to avoid chipping.
Important Note
Carrara White is a natural marble, and each piece may vary in tone and veining. Always inspect and dry-lay trim before installation for visual consistency. Stonemarket USA is not responsible for installation errors or natural stone variation.
