Installation Guide – Phase Grey Storm Deco 12×24 Porcelain Tile Natural Rectified
Important Advisory
Always follow Happy Floors installation instructions, applicable local building codes, and recognized tile industry standards such as ANSI A108/A118 and TCNA guidelines. Confirm that the substrate, setting materials, waterproofing, drainage, movement accommodation, and site conditions are appropriate for the intended application.
Step 1: Layout & Planning
- Confirm the tile, color, shade, and lot information before installation. Blend material from multiple boxes as appropriate to distribute design variation evenly.
- Verify that the substrate is clean, dry, structurally sound, and properly prepared for porcelain tile. Plan the layout to balance the pattern and avoid unnecessarily narrow perimeter cuts.
- Dry-lay or reference-plan the installation before setting tile, paying close attention to the Deco pattern and the orientation of adjacent pieces.
- Use spacers or an approved layout method to maintain consistent joints. Provide movement accommodation at perimeters, changes of plane, and other locations required by the installation conditions and industry guidelines.
Step 2: Tile Installation
- Use a setting material approved by its manufacturer for porcelain tile and the specific substrate and application.
- Apply mortar to the prepared substrate using the method and coverage recommended by the mortar manufacturer. Set each tile with appropriate contact and alignment, checking periodically for adequate coverage.
- Maintain the planned orientation of the Deco design and keep rectified edges properly aligned. Use an appropriate leveling or alignment system if needed for the installation.
- Do not disturb or place the installation into service until the setting material has cured according to the manufacturer’s instructions.
Step 3: Cutting
- Use a wet saw or other professional cutting equipment with a diamond blade suitable for porcelain tile.
- Measure and mark cuts carefully, and support the tile during cutting to help reduce chipping.
- Ease or finish exposed cut edges as appropriate for transitions, corners, or other visible locations.
Step 4: Joint Filling
- Select grout suitable for porcelain tile, the planned joint width, and the installation environment. Follow the grout manufacturer’s instructions for mixing, application, cleaning, and curing.
- Pack joints fully, remove excess grout carefully, and clean the tile surface without disturbing the joints.
- Use an appropriate flexible sealant rather than grout at movement joints, changes of plane, and perimeter joints where required.
- Protect the finished installation from traffic, moisture, and impact until the grout and setting materials have cured as directed.
Step 5: Cleaning & Maintenance
- Remove installation residue promptly using products recommended for porcelain tile and the setting-material manufacturers’ instructions.
- Maintain the surface with a pH-neutral cleaner suitable for porcelain tile. Avoid harsh abrasives and unapproved acidic products.
- Use mats or other appropriate measures in high-traffic areas to reduce tracked-in grit. Follow the grout manufacturer’s guidance for ongoing care and sealing, if applicable.
Disclaimer
Installation should be performed by qualified tile professionals. Always verify actual material, shade variation, pattern alignment, substrate conditions, and application suitability before installation. Stone Market USA is not responsible for issues resulting from improper installation, handling, maintenance, or site conditions.