Installation Guide – Happy Floors Phase Dark Storm Deco 12×24 Porcelain Tile Natural Rectified
Important Advisory
Always follow the Happy Floors installation instructions, applicable local building codes, and recognized tile-industry standards, including relevant ANSI and TCNA guidance. Confirm that the substrate, setting materials, waterproofing, drainage, movement accommodation, and intended application are appropriate before installation.
Step 1: Layout & Planning
- Inspect all cartons before installation and confirm the product, size, color, finish, and lot information. Do not install material with visible defects.
- Verify that the substrate is clean, dry, structurally sound, and appropriately flat for the selected tile format and installation area.
- Plan the layout by dry-laying or measuring the space to balance the design and avoid unnecessarily narrow perimeter cuts.
- Blend tiles from multiple boxes during installation to distribute normal shade and pattern variation throughout the finished surface. Rectified edges do not eliminate the need for a suitable grout joint.
Step 2: Tile Installation
- Use a setting material approved for porcelain tile and appropriate for the substrate and application. Follow the setting-material manufacturer’s preparation and working instructions.
- Apply mortar to the properly prepared substrate using an appropriate method for the tile size and installation conditions. Back-buttering may be appropriate where needed to improve contact and coverage.
- Set each tile with a controlled back-and-forth motion to promote proper mortar transfer. Check coverage periodically and adjust the installation method as required for the application.
- Maintain the planned alignment and joint spacing, and provide movement accommodation at required perimeters, changes of plane, and field locations in accordance with industry guidance.
- Allow the setting material to cure according to its manufacturer’s instructions before grouting or exposing the installation to traffic or moisture.
Step 3: Cutting
- Cut porcelain tile with equipment and a diamond blade suitable for porcelain.
- Measure and mark carefully, support the tile fully during cutting, and use appropriate safety equipment.
- Ease or finish exposed cut edges where needed at transitions, corners, or other visible locations.
Step 4: Joint Filling
- Select grout compatible with porcelain tile, the planned joint width, and the installation environment. Follow the grout manufacturer’s instructions for mixing, application, cleaning, and curing.
- Pack joints fully and remove excess grout carefully without disturbing the tile alignment or joints.
- Use an appropriate flexible sealant rather than grout at movement joints, changes of plane, and other locations requiring flexible accommodation.
- Protect the completed installation from traffic and moisture until the grout and setting materials have cured as directed.
Step 5: Cleaning & Maintenance
- Remove installation residue using products recommended for porcelain tile and the selected grout. Avoid harsh acids, abrasive cleaners, and tools that may damage the finish or joints.
- For routine care, use a pH-neutral cleaner suitable for porcelain tile and clean spills promptly.
- Use mats, rugs, or protective pads where appropriate to reduce tracked-in grit and protect adjacent surfaces.
- Follow the grout and setting-material manufacturers’ maintenance recommendations, including any guidance regarding sealing cementitious grout.
Disclaimer
Installation should be performed by qualified tile professionals familiar with the specific site conditions and materials. Confirm actual product variation, substrate suitability, and application requirements before installation. Stone Market USA is not responsible for issues caused by improper installation, handling, or site conditions.