Phase Dark 12×24 Porcelain Tile Natural Rectified
Sophisticated and modern, the Phase Dark 12×24 porcelain tile delivers a rich, dark tone with a versatile natural (matte) surface. The elongated format helps create streamlined layouts and fewer grout lines for a clean, contemporary look on walls or floors.
Engineered in durable porcelain with rectified edges, Phase supports tight, consistent joints and dependable performance in busy spaces. A PEI 5 wear rating provides robust surface durability, while frost resistance expands design possibilities to exterior facades in freeze–thaw climates.
Use it on its own for sleek minimalism or pair it with coordinating elements to build layered detail. The natural finish offers a soft, low-sheen look that complements a wide range of materials and palettes.
Features
- Porcelain body for durability and easy care
- Color: Dark
- Finish: Natural (matte)
- Edge: Rectified for precise, narrow grout joints
- Size: 12×24 tile
- PEI 5 wear rating for heavy-duty foot traffic
- Frost resistant for freeze–thaw exterior wall applications
- Coverage: 13.56 sq. ft. per box | 7 pieces per box
Recommended Applications
- Residential interior floors
- Residential interior walls
- Light commercial interior floors
- Commercial interior walls
- Backsplashes
- Shower walls
- Fireplace surrounds
- Exterior walls/facades (freeze–thaw)
Installation Guide – Phase Dark 12×24 Porcelain Tile Natural Rectified
Important Advisory
Always follow the tile manufacturer’s instructions, local building codes, and recognized industry standards (e.g., ANSI A108/A118 and TCNA). Ensure proper substrate preparation, movement accommodation, and waterproofing/drainage where required.
Step 1: Layout & Planning
- Confirm the substrate is clean, dry, structurally sound, and flat within tolerances appropriate for the tile size.
- Dry-lay to plan the layout, balance cuts, and align patterns; avoid small slivers at perimeters.
- Blend material from multiple boxes to distribute any shade or pattern variation.
- Use spacers and a joint width appropriate for rectified tile; include movement joints per TCNA EJ171.
Step 2: Tile Installation
- Use a polymer‑modified thinset mortar approved for porcelain and, if needed, for larger-format tiles like 12×24.
- Key mortar into the substrate, then comb with an appropriate notched trowel. Back‑butter tiles as needed to improve bond.
- Set tiles with a slight back‑and‑forth motion to collapse ridges; achieve mortar coverage consistent with application and location (commonly 80–95%).
- Use a leveling system if needed to help minimize lippage on 12×24 layouts.
- Allow the mortar to cure per manufacturer instructions before grouting or light traffic.
Step 3: Cutting
- Cut with a wet saw using a premium diamond blade rated for porcelain.
- Mark cuts carefully and support the tile fully to help reduce chipping.
- Ease sharp cut edges as needed where edges may remain exposed.
Step 4: Joint Filling
- Select a grout suitable for porcelain and the chosen joint width; follow manufacturer directions for mixing and cure.
- Pack joints fully with a rubber float, clean diagonally, and remove haze promptly with clean water.
- Use appropriate sealants at movement joints and changes of plane; do not grout these areas.
- Protect the installation from traffic until grout has cured per manufacturer guidance.
Step 5: Cleaning & Maintenance
- Clean routinely with a pH‑neutral cleaner suitable for porcelain; avoid acids and harsh abrasives.
- Use entry mats and protective pads to help reduce tracked‑in grit and scratching.
- Follow grout manufacturer maintenance recommendations; seal cementitious grout if specified.
Disclaimer
Installation should be performed by qualified professionals. Verify actual materials, lot-to-lot variation, and suitability for the intended application before installation. Stone Market USA is not responsible for issues arising from improper installation, handling, or site conditions.
