Add timeless charm to your design with the Triverra 6×24 3D Ledgestone Panel. Made from natural travertine, this panel features a preaged surface that blends warm beige, cool grey, and soft brown tones. Its three-dimensional layout creates texture and depth on any vertical surface.
This stone panel is ideal for accent walls, fireplace facades, outdoor kitchens, or commercial interiors. Because it is chemically bonded and not mesh-backed, it ensures long-lasting structure and easy installation. The interlocking design offers a seamless, dry-stack appearance that enhances both rustic and modern spaces.
- Stone Type: Travertine
- Finish: Preaged 3D Surface
- Size: 6″x24″ Panel
- Use: Vertical surfaces only
- Setting: Indoor and Outdoor
- Installation: Chemically adhesed (not mesh-backed)
Installation Guide – Triverra 6″x24″ 3D Ledgestone Panel (Travertine)
Important Notes
- This product is made of natural travertine and is designed for vertical wall use only.
- Do not use for flooring or horizontal surfaces due to its 3D surface and porosity.
- Use chemical-sensitive, stone-safe adhesives and cleaners only.
Step 1: Surface Preparation
- Ensure the substrate is structurally sound, clean, dry, and level.
- Acceptable substrates: cement board, concrete, masonry block.
- Apply a waterproofing membrane for wet areas (e.g., showers or outdoor walls).
- Use a level line to keep rows even during install.
Step 2: Dry-Fit Layout
- Lay out panels on the ground to blend color and texture variations before applying to wall.
- Stagger vertical joints for a more natural and continuous appearance.
- Use corner pieces for outside edges, if available.
Step 3: Adhesive Application
Recommended Adhesives:
- Laticrete® 255 Multimax or 254 Platinum
- Mapei® Ultraflex LFT with white base
- Do not use premixed mastic or acidic bonding agents.
Instructions:
- Apply adhesive to both the wall and back of each panel using a 1/2″ notched trowel.
- Back-butter each panel for full coverage, especially due to uneven back surfaces on 3D pieces.
- Press firmly with a sliding motion and hold momentarily to allow adhesion.
Step 4: Cutting & Handling
- Use a wet saw with a diamond blade designed for natural stone.
- Cut slowly and support the panel properly to avoid cracks or chipping.
- Wear protective eyewear and gloves when handling travertine.
Step 5: Finishing Touches
- This is a dry-stack panel – no grout required.
- Clean off excess mortar from panel faces with a damp sponge before it sets.
- Allow to cure undisturbed for at least 24–48 hours.
Step 6: Sealing
- Apply a high-quality penetrating sealer made for travertine after curing.
- Do not use topical coatings that alter the natural texture or cause yellowing.
- Reapply sealer every 1–2 years, depending on exposure.
Maintenance
- Use only pH-neutral, non-acidic stone cleaners.
- Avoid bleach, vinegar, or harsh chemicals that may etch or discolor the surface.
- Inspect and clean periodically to maintain appearance.
Disclaimer
This panel is designed for vertical wall application only. Always follow the adhesive manufacturer’s instructions when working with natural travertine. Due to the nature of travertine, minor pitting or surface variation is normal and part of the stone’s character.
