Silver Diamond 2×2 Inch Polished Luxurious Mosaic Tile –Marble Silver Gray

Maximize the Performance of Your Silver Diamond Square Polished Marble Mosaic Tile (12″ x 12″)

Follow these essential steps for preparing, installing, and finishing your Silver Diamond Square Polished Marble Mosaic Tile (12″ x 12″) to achieve a flawless and long-lasting installation. Proper installation ensures durability, stability, and aesthetic appeal while maintaining the luxurious polished marble finish and timeless square design.

Step 1: Surface Preparation

• Clean, dry, and free from dust, grease, soap scum, and debris.
• Structurally sound and level, with no cracks or loose sections.
• Properly waterproofed, especially in moisture-prone areas like bathrooms, kitchens, and showers.
• Clear of moldings or obstructions that may interfere with tile placement.
• If necessary, apply a self-leveling compound to create an even surface before installation.

Step 2: Layout Planning

• Measure the installation area and mark the center points of all four walls.
• Snap chalk lines to create a precise grid for alignment.
• Dry-lay tiles along the center lines to ensure balanced placement.
• Adjust center lines if edge cuts are too small.
• Use tile spacers (1.5mm – 3mm) for uniform grout joints.
• Dry-lay multiple sheets to confirm pattern alignment.

Step 3: Selecting & Applying Adhesive

Use a high-quality white thin-set mortar such as:

• Mapei
• Laticrete
• Ardex

Application Tips:

1. Mix only the amount of mortar usable within 30 minutes.
2. Apply a 1/4-inch layer using the flat side of a notched trowel.
3. Comb the mortar at a 45-degree angle to create ridges.
4. Work in 2′ x 3′ sections to avoid drying before placement.
5. Back-butter each tile to improve adhesion.

Step 4: Cutting & Fitting Tiles

• Mark tiles with a pencil or tile marker.
• Use a wet saw with diamond blade for clean cuts.
• Smooth edges with a rubbing stone.
• For intricate cuts, use a tile nipper or grinder.
• Dry-fit all tiles before applying adhesive.

Step 5: Setting the Tiles

• Start from the center of the room, working outward.
• Place tiles with a twisting motion for bond strength.
• Avoid sliding tiles into position.
• Use spacers to maintain grout lines.
• Tap gently with a rubber mallet.
• Wipe off excess mortar with a damp sponge.
• Allow to cure 24 hours before grouting.

Step 6: Grouting & Finishing

• Remove spacers before grouting.
• Use non-sanded grout to protect the polished finish.
• Spread grout diagonally with a rubber float.
• Remove excess grout immediately.
• After 15–20 minutes, clean haze with a damp sponge.
• Allow to cure 72 hours before use.
• Apply penetrating sealer after curing.

Maintenance Tips

• Use pH-neutral cleaners to protect the surface.
• Avoid acidic or harsh chemicals.
• Reseal regularly to maintain shine and durability.
• Place felt pads under furniture to prevent scratching.

Important Notice:

Stonemarket USA is not responsible for improper installations. We strongly recommend hiring a professional tile installer and using premium-grade materials for the best results.

📞 Need help? Contact Stonemarket USA Customer Support

By following these expert installation guidelines, you’ll enjoy the timeless beauty and durability of your Silver Diamond Square Polished Marble Mosaic Tile (12″ x 12″) for years to come.