Macaubas Twilight 12×24 Porcelain Tile Anticato Rectified

Installation Guide – Macaubas Twilight 12×24 Porcelain Tile Anticato Rectified

Important Advisory

Always follow Happy Floors installation instructions, applicable local building codes, and recognized industry standards such as ANSI A108/A118 and TCNA guidelines. Confirm that the selected substrate, setting materials, waterproofing, drainage, and movement-joint design are appropriate for the specific installation.

Step 1: Layout & Planning

• Verify that the substrate is clean, dry, structurally sound, and suitably flat for the selected tile format.
• Plan the layout before setting tile, balancing the design to reduce narrow perimeter cuts and maintain visual continuity.
• Inspect material from multiple boxes and blend pieces as needed to distribute natural shade and pattern variation.
• Establish joint widths appropriate for rectified porcelain tile and the selected layout. Provide movement accommodation at required locations and changes of plane.

Step 2: Tile Installation

• Use a mortar approved by the manufacturer for porcelain tile and the installation conditions.
• Apply mortar to the prepared substrate using a suitable method for the tile format, and ensure adequate contact between the tile and setting material.
• Set each tile with a slight back-and-forth motion to promote contact and alignment. Periodically lift tiles to verify coverage and adjust the installation method if needed.
• Maintain consistent alignment across the installation and use a suitable leveling aid where appropriate to help manage lippage.
• Allow the setting material to cure according to its manufacturer’s instructions before grouting or exposing the installation to traffic or moisture.

Step 3: Cutting

• Use a wet saw or other professional cutting equipment with a diamond blade suitable for porcelain tile.
• Measure and mark cuts carefully, and support the tile fully during cutting to help reduce chipping.
• Smooth or ease exposed cut edges where needed, particularly at transitions or other visible terminations.

Step 4: Joint Filling

• Select a grout compatible with porcelain tile, the planned joint width, and the service conditions of the installation.
• Follow the grout manufacturer’s instructions for mixing, application, cleaning, and curing.
• Fill joints thoroughly, clean the surface without allowing grout residue to remain, and remove haze using products recommended for porcelain tile.
• Use flexible sealant rather than grout at movement joints, inside corners, changes of plane, and other locations required by the installation design.

Step 5: Cleaning & Maintenance

• Remove installation residue using cleaners recommended for porcelain tile and the setting or grout materials used.
• Clean routinely with a suitable pH-neutral tile cleaner and avoid harsh abrasives or products that may damage the grout or finish.
• Address spills and tracked-in grit promptly, and follow the grout manufacturer’s maintenance and sealing recommendations where applicable.

Disclaimer

Installation should be performed by qualified tile professionals. Confirm actual material, shade variation, lot information, substrate conditions, and application suitability before installation. Stone Market USA is not responsible for problems resulting from improper installation, handling, or site conditions.