Myra Shell Limestone – 6×12 Beige Tumbled Paver

Installation Guide – Myra Shell Limestone Tumbled 6″x12″ Paver

Material Overview

• Natural limestone paver with a tumbled finish and softened edges.
• Designed for horizontal outdoor applications such as patios, walkways, pool decks, and courtyards.
• Suitable for both dry-set and wet-set installation methods.

Step 1: Base Preparation (Dry-Set Installation)

1. Excavate the installation area to a depth of approximately 6″–8″ based on climate and load requirements.
2. Install 4″–6″ of compacted crushed gravel or road base, compacting in layers.
3. Add about 1″ of bedding sand and screed evenly to create a flat surface.

Step 2: Laying the Pavers

• Lay the 6″x12″ limestone pavers in the desired pattern such as running bond or herringbone.
• Maintain joint spacing of approximately 1/8″–1/4″ to allow for natural variation.
• Do not use grout for dry-set applications.

Step 3: Cutting

• Use a wet saw or angle grinder with a diamond blade suitable for natural stone.
• Perform cutting outdoors and use proper safety equipment.

Step 4: Joint Filling

• Sweep polymeric sand or joint sand into the joints.
• Compact the surface and refill joints if needed.
• Lightly mist with water to activate polymeric sand.

Alternative: Wet-Set Installation

• Apply exterior-grade mortar or thin-set over a concrete slab.
• Back-butter each paver for proper adhesion.
• Clean excess mortar from joints immediately.

Sealing & Maintenance

• Apply a penetrating, breathable sealer designed for limestone.
• Reseal every 1–2 years depending on exposure and traffic.
• Clean with a pH-neutral stone cleaner; avoid acidic products.

Disclaimer

Limestone is a natural material and may show color variation, shell fossils, and surface texture differences.
These characteristics are inherent and enhance the stone’s natural appearance. Always perform a dry layout
before final installation and follow local building codes.