Myra Beige 1×2 Herringbone Honed Limestone Mosaic Tile

Maximize the Performance of Your Myra Beige 1×2 Herringbone Honed Limestone Mosaic Tile

Achieve a flawless and long-lasting installation by following these essential guidelines for preparing, installing, and finishing your Myra Beige 1×2 Herringbone Honed Limestone Mosaic Tile. Proper installation ensures durability, structural stability, and a refined appearance while preserving the natural texture and elegance of honed limestone.

Step 1: Surface Preparation

A properly prepared surface is critical for a successful installation. Ensure the substrate is:

• Clean, dry, and free of dust, grease, soap residue, and debris
• Structurally sound, level, and free of cracks or loose areas
• Correctly waterproofed in wet areas such as bathrooms, kitchens, and showers
• Clear of moldings or obstructions that may interfere with tile placement
• Leveled with a self-leveling compound if necessary

Step 2: Layout Planning

• Measure the installation area and mark center points on all walls
• Snap chalk lines to create accurate reference lines for alignment
• Dry-lay multiple mosaic sheets to confirm pattern flow and visual balance
• Adjust layout if edge cuts become too small or uneven
• Use appropriate spacers (1.5 mm – 3 mm) for consistent grout joints
• Verify continuous herringbone alignment before applying adhesive

Step 3: Adhesive Selection & Application

Use a high-quality white thin-set mortar approved for natural limestone. Premium brands such as Mapei, Laticrete, or Ardex are recommended.

• Mix only the amount of mortar that can be used within 30 minutes
• Apply mortar using the flat side of a notched trowel
• Comb the mortar with the notched side at a 45-degree angle
• Work in small sections to prevent premature drying
• Back-butter the mosaic sheets when required to improve adhesion

Step 4: Cutting & Fitting

• Mark tiles accurately using a pencil or tile marker
• Use a wet saw with a diamond blade suitable for natural stone
• Smooth cut edges with a rubbing stone to maintain a clean finish
• Dry-fit all cuts before final installation to ensure pattern continuity

Step 5: Setting the Mosaic

• Begin installation from the center reference lines and work outward
• Set mosaic sheets using gentle pressure and a slight twisting motion
• Avoid sliding sheets to prevent mortar displacement
• Use spacers to maintain uniform grout joints
• Lightly tap sheets with a rubber mallet for even placement
• Remove excess mortar immediately with a damp sponge
• Allow adhesive to cure for a minimum of 24 hours before grouting

Step 6: Grouting & Finishing

• Remove spacers before grouting
• Use non-sanded grout to protect the honed limestone surface
• Apply grout diagonally using a rubber float to fully fill joints
• Remove excess grout promptly
• After initial set, clean grout haze with a damp sponge
• Allow grout to cure for at least 72 hours before heavy use
• Apply a penetrating sealer after grout has fully cured

Maintenance Guidelines

• Clean regularly using pH-neutral, stone-safe cleaners
• Avoid acidic, abrasive, or harsh chemical products
• Reseal periodically to maintain stain resistance
• Use protective pads under furniture to prevent surface damage

Important Notice

StoneMarket USA is not responsible for improper installation. For optimal results, professional installation by a qualified tile installer is strongly recommended.

By following these installation guidelines, your Myra Beige 1×2 Herringbone Honed Limestone Mosaic Tile will maintain its natural beauty, durability, and refined appearance for years to come.