Add timeless warmth and dimension to your walls with the Royal Beige 6×24 3D Ledgestone Panel. Made from natural marble, this panel features a warm beige tone and subtle textural veining. Its 3D honed surface introduces depth and movement, transforming plain walls into bold architectural statements.
Thanks to its clean-cut edges and easy-to-handle size, installation is straightforward. Unlike mesh-backed options, each panel is factory-assembled and chemically bonded, which ensures greater durability and long-term performance. Whether you’re designing a feature wall, cladding a fireplace, or upgrading an exterior facade, this panel offers versatile beauty that lasts.
- Stone Type: Natural Royal Beige marble
- Finish: Honed, with 3D dimensional finish
- Color: Beige with soft natural variation
- Size: 6″ x 24″ (15.2 cm x 61 cm)
- Installation: For vertical surfaces only – interior or exterior
- Assembly: Chemically bonded for added strength (not mesh-backed)
- Best Uses: Fireplace surrounds, feature walls, backsplashes, commercial walls
Choose the Royal Beige 3D Ledgestone Panel for a natural marble finish that adds both character and class. It’s an ideal choice for designers seeking subtle color with architectural flair.
Installation Guide – Myra Shell 6″x24″ 3D Ledgestone Panel (Limestone)
Step 1: Surface Preparation
- Ensure the vertical surface is structurally sound, clean, dry, and free from contaminants.
- Acceptable substrates include cement backer board, concrete, or masonry block.
- Install a waterproof membrane in wet or exterior areas.
- Limestone is porous—avoid direct installation over drywall.
Step 2: Layout Planning
- Dry-lay several pieces to understand color and texture variations.
- Start from the bottom and work upwards in a staggered layout.
- Use a level and snap horizontal chalk lines to maintain alignment.
Step 3: Adhesive Application
Recommended Adhesives for Limestone:
- Laticrete 254 Platinum or Mapei Ultraflex LFT (non-acidic, flexible mortars)
- Use white thin-set to prevent shadowing through the light-colored limestone.
Instructions:
- Apply adhesive to both the wall and the back of the panel using a 1/2″ square-notched trowel.
- Back-butter each piece to ensure full contact.
- Press the panel firmly into place and slide slightly for better bond.
Step 4: Cutting & Fitting
- Use a wet saw with a diamond blade suitable for soft natural stone.
- Always wear protective gear and cut outdoors or in a well-ventilated space.
- Pre-fit all corner and edge pieces before securing them in place.
Step 5: Finishing
- No grout required for dry-stack installation.
- Clean excess adhesive immediately with a damp sponge.
- Allow panels to cure for 24–48 hours before exposure to water or handling.
Step 6: Sealing
- Limestone is porous—apply a high-quality penetrating sealer safe for natural stone.
- Do not use acidic or solvent-based sealers, which may damage the surface.
- Reapply sealer every 1–2 years depending on exposure conditions.
Maintenance Tips
- Clean using pH-neutral stone cleaner and a soft cloth or brush.
- Avoid acidic or abrasive cleaners that can etch or dull the surface.
Disclaimer
This product is intended for vertical wall applications only. Variations in color, veining, and texture are inherent characteristics of natural limestone. Always inspect the product before installation. Improper installation or use of unsuitable adhesives or chemicals may result in permanent damage. Professional installation is recommended.
