Salt Stone Ash 12×24 Porcelain Tile Natural Pressed
Refined and versatile, the Salt Stone Ash 12×24 porcelain tile brings a modern ash tone and a soft natural matte surface to kitchens, baths, living areas, and more. Its 12×24 format creates clean, streamlined layouts on floors and walls, while pressed edges accommodate consistent grout joints.
Engineered in durable porcelain at 3/8" (9mm) thick, this tile delivers everyday performance with a PEI 4 wear rating and a wet DCOF greater than 0.42. Frost resistance supports exterior wall applications in freeze–thaw climates. Box coverage is 13.66 sq. ft. (7 pieces) to simplify estimating and ordering.
Blend tiles from multiple boxes to balance shade and pattern variation as desired, and pair the ash hue with warm woods, dark metals, or light cabinetry for a balanced, contemporary palette.
Features
- Material: Porcelain
- Color: Ash
- Finish: Natural (matte)
- Edge: Pressed
- Size: 12×24
- Thickness: 3/8" (9mm)
- PEI Rating: 4
- DCOF: >0.42 (wet)
- Frost resistant (freeze–thaw)
- Coverage: 13.66 sq. ft. per box | 7 pieces per box | approx. 1.951 sq. ft. per piece
Recommended Applications
- Residential interior floors
- Residential interior walls
- Light commercial interior floors
- Commercial interior walls
- Backsplashes
- Shower walls
- Fireplace surrounds
- Exterior walls/facades (freeze–thaw)
Installation Guide – Salt Stone Ash 12×24 Porcelain Tile Natural Pressed
Important Advisory
Always follow the tile manufacturer’s instructions, local building codes, and recognized industry standards (ANSI A108/A118 and TCNA guidelines). Verify substrate suitability, movement accommodation, and waterproofing/drainage where required.
Step 1: Layout & Planning
- Confirm the substrate is clean, dry, sound, and flat within industry tolerances for the chosen tile size.
- Plan the layout by dry-laying tiles, centering the design, and avoiding narrow perimeter cuts.
- Blend material from multiple boxes to distribute shade variation evenly.
- Select a grout joint appropriate for pressed-edge tile and include movement joints per TCNA EJ171.
Step 2: Tile Installation
- Use a polymer-modified thin-set mortar approved for porcelain tile and the project conditions (interior/exterior, wall/floor).
- Key mortar into the substrate, then comb with an appropriate notched trowel to achieve full coverage; back-butter as needed.
- Set tiles with a slight sliding motion to collapse ridges and promote bond; target coverage consistent with location and service (typically 80–95%).
- Use a leveling system if needed to help control lippage on flatter installations.
- Allow mortar to cure per manufacturer instructions before grouting or light traffic.
Step 3: Cutting
- Cut with a wet saw using a premium diamond blade suitable for porcelain.
- Mark cuts carefully and support the tile fully to minimize chipping.
- Ease sharp cut edges where they will be exposed.
Step 4: Joint Filling
- Choose a grout suitable for porcelain and the selected joint width; follow manufacturer directions for mixing and application.
- Pack joints fully with a rubber float, then clean diagonally and remove haze promptly with clean water.
- Use flexible sealants at changes of plane and movement joints; do not grout these areas.
- Protect the installation from traffic until grout has cured as specified.
Step 5: Cleaning & Maintenance
- Clean routinely with a pH-neutral cleaner made for porcelain tile; avoid acids and harsh abrasives.
- Use entry mats and protective pads to reduce tracked-in grit and potential scratching.
- Follow grout manufacturer maintenance guidance; seal cementitious grout if recommended.
Disclaimer
Installation should be performed by qualified professionals. Confirm actual lot characteristics and suitability for the intended application before installation. Stone Market USA is not responsible for issues arising from improper installation, handling, or site conditions.
